WW Collet Set, P/N 1160

Collets provide a quick, easy method of mounting cylindrical parts or bar stock in the lathe with a great deal of centering accuracy. Each collet is actually a small, precision 3-jaw chuck that fits into a special tapered adapter in the headstock. A drawbar that passes through the headstock and threads into the back side of the collet is used to draw the collet up into the tapered adapter. The adapter causes the jaws of the collet to close down, gripping the part to be machined. Typically, collets provide a very accurate part mounting system, but each size collet can accommodate only a small range of diameters of approximately ±.001" (.02mm).

WW collets differ from milling collets (P/N 3060) in that they have a hole all the way through the collet and drawbar. The maximum diameter stock that can pass entirely through the collet is 3/16" or 4.5mm. The WW collets that are larger than this diameter are sometimes referred to as "pot" chucks.

The Sherline WW collet set includes a WW style collet taper adapter, a drawbar, and a set of five WW collets with .275-40 thread, sizes 1/16", 1/8", 3/16", 1/4", and 5/16". A metric (P/N 1178) WW collet set is also available and includes sizes 2.0mm, 3.0mm, 4.0mm, 5.0mm, and 6.0mm. These collets are manufactured by Sherline and are built to standard WW specifications; however, we have come across collets that are called WW and will not fit our drawbar and adapter. Be sure to check WW collets made by other manufacturers to be sure they fit our adapter before you purchase them. Sherline manufactures a slightly larger .315" adapter and drawbar set (P/N 1163) that will accommodate some of these other brands.

More complete collet sets...

Sherline also offers sets that include a more complete selection of collets. The P/N 1162 set includes 17 inch size collets from 1/16 to 5/16", while the P/N 1179 set includes 14 metric collets from 1.5 mm to 8.0 mm. These sets come in an oak box with a divider that has extra holes for more collets should you add them later. It also includes a drawbar, collet adapter, knockout bar, two collet pot chucks and a collet blank.

The most complete set we offer is the P/N 1180 metric set that include 78 collets from 0.3 mm to 8.0 mm by 0.1 mm increments. This comes in an oak box with 96 holes in case you add some inch sizes but does not include the adapter, drawbar or other accessory items in the 1162 or 1179 sets described above.

READ INSTRUCTIONS FOR USING WW COLLETS (Click on your choice.)

.html Version (Web site version)

.pdf Version (The same as our printed instructions. Requires Adobe Acrobat program to view.)