Mill Headstock Spacer, P/N 1297

Having the option to extend the headstock further out can sometimes allow surfaces to be machined that could not otherwise be reached without breaking down the setup and re-clamping the part. The spacer moves the spindle out an additional 1-1/4". In many cases, it is much easier to increase your machinable surface area by using this spacer than to re-clamp the part. Precisely machined keyways keep the headstock accurately aligned. A precision ground alignment key is included.

NOTE: This part is the same as the lathe headstock spacer block, so you need not duplicate it if you already have the P/N 1291 spacer block kit unless you wish to leave the spacer block in place on either the lathe or mill and don't wish to deal with changing it back and forth between machines. Also note that the Model 5400 mill comes with this spacer block as part of its standard equipment. The Model 2000 mill has ram in/out adjustment that, for the most part, eliminates the need for this accessory, so it is not included with that mill. There may still be special setups where you would find it useful on that machine as well.

READ INSTRUCTIONS FOR USING A MILL HEADSTOCK SPACER BLOCK (Click on your choice.)

.html Version (Web site version)

.pdf Version (The same as our printed instructions. Requires Adobe Acrobat program to view.)