Back to Tool Holders

Cutoff Tool and Holder

-

SKU: 3002 Category:

Product Description

After completing a part in the lathe it is frequently necessary to separate the part from the excess material used for chucking. This operation is best accomplished with the use of a cutoff tool or “parting tool” as it is sometimes called. The Sherline cutoff tool and holder consist of a very slender high-speed tool steel cutting blade mounted in a special holder. The thinness of the blade (.040″ or 1 mm) enables it to feed into the part quite easily, and, at the same time, minimizes the amount of waste material. The turning speed for parting should be approximately one-half the normal turning speed for any given material.

The cutoff tool can be used on the “back” side of the tool post with the addition of the rear mount riser (shown below).

3016_Cutoff-Tool-Rear-Mount-Block

Precaution:
Never use a parting tool on a part mounted between centers. The part can bind on the cutter and result in a scrapped part or a broken tool. A small amount of cutting oil is a must. Parting off free-machining material over a 1.00″ (25 mm) diameter will always be a problem on a machine of this size.

warning-symbol
The improper use of machine tools and their accessories can result in serious injury. Before using this tool, thoroughly read the instructions and make sure you understand its proper and safe use.

safety-glasses-symbol

Always wear safety glasses when operating machine tools.


Download PDF 3002 Instructions

Instructions PDF Download

Body Material Aluminum
Body Coating Black Anodized
Body Dimensions (H x W X D) 1.5″ x 1.25″ x 1.25″
Cutoff Tool Blade Material High Speed Steel
Cutoff Tool Blade Dimensions (thickness x height X length) .04″ x .5″ x 3.5″
Part No. Description Quantity
30850 Cutoff Tool Holder Body 1
30860 Cutoff Tool Blade 1
40250 Tall T-Nut 1
40590 1/4″ Washer 1
40740 10-32 x 7/8″ SHCS 2
40710 10-32 x 1-1/4″ SHCS 1